You see prices for your delivery country Germany with 19% tax.
You can change the country of delivery in the menu above.XT:LINE - Audio Transmitter Analog
€189.00*
Available immediately, delivery time: 1-3 days
| Analog audio transmitter to transmit audio signals over 300m |
What you need to know about the XT:LINE
The trivum audio extender devices are professional solutions for transmitting audio signals over long distances using standard network cables.
The trivum XT:LINE is an audio transmitter with analog inputs. In conjunction with the optionally available XR:LINE, you can, for example, transmit the sound from a TV or CD player to the equipment room using a CAT cable. There, the trivum XR:LINE receiver then passes the audio signal on to an amplifier or multi-room system. If the source or a control device provides a trigger signal, this signal is passed on to the receiver.
- Extends analog audio signals up to 300m over standard network cables
- Ground lift switch to isolate the signal ground
- Trigger input for any DC/AC voltages between 5-24V
- LED to indicate the operating status
- Requires a trivum XR-LINE adapter as audio receiver for operation
- Only one power supply unit must be used. This can be plugged into the receiver or transmitter.
Features of the XT:LINE
The trivum audio extender solution has the following advantages over direct connections (simple adapters or adapters with galvanic isolation):
- up to 300 meters
The active symmetrical transmission of the signals (audio + trigger + power supply) is the basis of the trivum Audio Extender solution. - Interference-free
The principle of balanced audio transmission minimizes noise caused by interference in the cable path. This complex technical solution is now standard in many studios due to its advantages. - Hum-free
The active galvanic isolation of the transmitter and receiver prevents hum loops caused by potential differences. - Neutral sound
In contrast to the solution using passive galvanic isolation with transformers, the trivum solution has a better sound because transformers change the sound image and cut or distort the frequency response. The OP amps used in the active trivum extenders are technically far superior to the passive solution. - No time delay
In contrast to products that work via IP networks, the trivum solution has no delay. IP solutions (wireless or cable) have to digitize the audio signal, then transmit the data in packets over the network, then reassemble it in a buffer and finally convert it into an audio signal. This takes too long to transmit lip-synchronized TV sound, for example. - With trigger signal
A trigger signal is passed potential-free from the transmitter to the receiver. The voltage is adjusted to 12V. The trigger input reacts with high impedance to voltages between 5V and 24V. The trigger signal is then available at the receiver with a load of 12V / 80mA. - Groundlift switch
Groundlift prevents ground loops as it separates the signal ground of the transmitter and receiver. Groundlift should therefore be active by default. In rare cases, however, it may be helpful not to activate Groundlift: If excessive interference is not produced by ground loops. This interference (whistling, humming, rattling) is caused by unclean switching power supplies or plug-in power supplies without earthing. - Unproblematic placement
In contrast to passive galvanic isolation using transformers, the trivum solution is not magnetically susceptible to interference. The adapter can therefore be placed anywhere, even in the vicinity of power supply units.
Connections
- Input
- 2x RCA (1x analog stereo L/R)
- 1x 2-pin socket with terminal block
- 1x socket for barrel connector (power supply)
- Output
- 1x RJ45 (1x audio bus with CAT 5/6/7 cable up to 300m)
Technical specifications
- Operating temperature: 0°C to 50°C
- Operating voltage: 12-15V (connect power supply either to transmitter or receiver)
- Power consumption: at 12V 65mA
- Trigger input: 5-24V DC/AC voltage
- Color: Black
- Weight: 0.116kg
- Dimensions (WxDxH): 95x55x32mm
Scope of delivery
- 1x trivum XT-LINE Analog Audio Transmitter
- 1x 2-pole terminal block for trigger input
- Note: No 15V power supply unit is included
- Note: XR-LINE Audio Receiver is not included
Connection example
1. analog stereo line input
2. trigger input
3. ground lift switch
4. audio bus out
